Alabama homebrew recipes (juice not shine)

[SammyT]

If you have any good juice recipes you can share them with your fellow alabamians here. If you can, keep it to percentages, and put the flavor's brand i.e. FA (flavour art) TFA (the flavor apprentice) TPA (the perfumers apprentice) CAP (Capella's) FW (flavor west) TP(tasty puff) LA (LorAnn) VZ (Vaping Zone). If you have any suggestions for additions or subtractions to taste post that as well. Or suggested watts or voltage/ohms. Also if you have a time of day you particularly enjoy it or if it complements a meal or beverage you should list that too. Please feel no need to elaborate this much, but it can't hurt .Let's get to mixing!


-Sam

[SammyT]

Squirrel's Tail Tobacco:
4% Burley FA
0.5% pecan TFA
0.5% vanillin TFA
1% tobacco blend TFA
3% 7Leaves Ultimate FA

Hot steep, let sit for a week, then take the cap AND nipple off. Let it breathe for a minute and cap it up and shake shake shake. Wait one more week, shake and vape. Hope you like it. You can always add a bit more vanillin or pecan if you want more of those notes. Add alittle vape wizard if the flavor is too sharp, but it should be smooth as silk. Happy mixing!


-Sam

[SammyT]

A good place to get flavors is: http://www.ecigexpress.com
A good place to get 100mg nicotine liquid is http://www.myfreedomsmokes.com do not take this stuff lightly, be careful and wear rubber gloves. Do not allow this stuff to touch your skin.
This is the best e-juice calculator IMO: http://ejuice.breaktru.com
Another good place to get ALCOHOL based flavors is:http://www.vapingzone.com

-Sam

[CES]

Sammy, how do you do a hot steep?

And please, everyone, if you're planning to DIY, especially if you're planning to use 100mg/ml nicotine, read the safety stickies from the DIY subforum.

Read this first

PG/VG labeling and purity: Please read!

***DIY Warning....Please read***

take the extra time and make sure you know what you're mixing and that your calculations are correct

[SammyT]

Thanks CES, safety first. I do a hot steep by heating water in a kettle, not boiling but hot enough where it is uncomfortable to wet your finger. Others run hot water from the tap, but my water heater doesn't heat water hot enough. Then I use either a shot glass or a mug with a rag stuffed in the bottom and put the juice IN THE BOTTLE in the hot water with the.cap on tight. The goal is to to not let water reach the lid. Let it go for about a half hour in the hot water and shake it for a minute. Then your done, let it sit as you see fit. I suggest a week at least if it is a tobacco flavor.


-Sam

[CES]

thanks Sammy!

[Kamin_Majere]

So does anyone know how to make an extremely tart cranberry?

[SammyT]

try this Kamin, it would be a good starting place.
5% http://www.ecigexpress.com/flavoring...capella-p-1177
0.5% http://www.ecigexpress.com/diy-suppl...-powder-p-1087
and then add more of each to taste. the Malic acid should be diluted in 10 ml pg

[Kamin_Majere]

cool, i'll have to give that a try... though it still terrifies me lol

Could you maybe add the cranberry and malic acid to something that already is made? Like if i can get the tobacco/raspberry blended perfect could this be added to give it a tart cranberry flavor as well?

[SammyT]

Absolutely, but it will drop your mg nic strength. Just use the e juice calculator linked above. There is nothing to be afraid of if you read warnings and be careful. Steady hands and care. And RUBBER GLOVES!!


-Sam