Janty Stick 801/112 atty mod to KR808D-1 cartomizers

[Lightgeoduck]

First I would like to thank catholic83 for directing me to Cisco's posts
I would like to thank Cisco for giving me the nail idea through the connectors instead of wiring.
I think I need to add nubee to the thank you list I did read his post in the past and the 901 and KR808 are almost the same

Second I apologize for the crappy pics I did this at work and pics are from cell so not all steps were photographed properly.

I did not solider anything

Pic 1 is the KR808D-1 batt dissected parts needed male connector and tube

Pic 2 112 atty dissected removing coil leaving connector and tube

Pic 3 I placed a drill bit that fit tight into the center hole of the 112 connector.

I cut and shortened the kr808 tube and flared one end in order to press inside bigger 112 connector center

Pic 4 pressed kr808 connector back into its tube ensuring the drill bit is pressed into center hole if you cut tube currect length drill bit is snug

Pic 5 I placed 112 tube over mod and pressed 112 connector back inside tube

finished atty.

[Lightgeoduck]

Final Product in the Janty Stick with Cartomizer as well.

I did this mod because I love that the Janty Stick has a button AND uses regular lith batts. I don't mind the 801/112 but I love the KR808D-1 handy and travel ready carts.

if the KR808 batt(cig) went bad I would have to order specific cigbatt
also the JS doubles up as a passthrough so Now I have a multipurpose unit

I could have waited for the js 901 adapter (which I probably will still purchase since my atty got scratched will modding)

Anyway Let me know what ya think