My Ultrasonic Clean for my Atomizers

[Suicidebob]

Anyone ever try this with cartomizers and some sort of alcohol like vodka? I've had luck boiling cartos and it sounds like this may work to remove the gumming on the coil portion of the cart.

Hey Nick, I've used this for cartos as well. However, I run it on about 4-5 cycles (3 minutes for each cycle) and leave them to soak over night... Once done in the morning I pull them out, blow through the top and wipe the bottle- if it looks clean I'll leave it to sit for a full 1-2 days... If I still see dark juice or if it's not a clean/clear I'll do it over again.

It does work.

[AaronY]

Hey Nick, I've used this for cartos as well. However, I run it on about 4-5 cycles (3 minutes for each cycle) and leave them to soak over night... Once done in the morning I pull them out, blow through the top and wipe the bottle- if it looks clean I'll leave it to sit for a full 1-2 days... If I still see dark juice or if it's not a clean/clear I'll do it over again.

It does work.

Are they totally dry after 2 days?

[tlmoody27]

is this the same thing as one of those ultrasonic jewelry cleaners?

[AaronY]

is this the same thing as one of those ultrasonic jewelry cleaners?

Yup the same thing. Actually that is what it is.

[nothiefsallowed]

I got one too and they work great, using it as I write this

[AaronY]

I got one too and they work great, using it as I write this

Nice what do you use vinegar or distilled water? How many cycles do you run it on?

[AaronY]

I was told by the manufacture not to use the ultra sonic for AVAs. Just figure I would pass the info along