How do you fix bad USB Pass Throughs?

[BJ43]

http://www.e-cigarette-forum.com/for...-passthru.html

sorry

[panderson01]

So, another one dies on me!

The first thing I did when it came in the mail was this to both ends:



I will get one hit after I plug it in and if I wait a few minutes, I may get another draw.

I guess I will just have to get the DSE 901 and try to make one of those tire valve ones until the passtrhough technology gets worked out.

[zedbra]

Hi, just got my usb pass through today, it is making the atomiser so hot I cannot hold it, have tried with another atomiser and does the same, any ideas please

[booboo]

They like ALOT of juice.....if they think it is even remotely dry in there, they get hot and will burn themselves out!

[ApOsTle51]

the only 2 things it can be is a failed vacum switch ( most likely ) or a broken connection.

Some wires will break withing the cable itself and not necessarally at the contact points.

[Jimbob]

The thing about these that is so sweet is no more crappy batteries to buy, and there really isn't much to break... the circuit inside should last almost forever... well except the wiring but that is easily soldered.

Anyone know where we can get a good USB passthru for the RN4081 that has a battery safety (like the Janty USB)? I see puresmoker.com has them, but no battery safety. The reason I want it is that plugging it directly into the USB tends to give more voltage then normal and atomizers aren't fond of it. But Janty was smart and added that extra little battery compartment to fix that issue.
So has any company professionally made one for the RN4081 though? I got one rigged, but talk about U-G-L-Y!

[Khandurian]

I have the usb passthru for the rn4081. It does not have that battery. It works just fine without it. However, to answer your question, I saw them on eastmalls website.

[Jimbob]

Thanks Khandurian!

[wanderlust]

I just go the missing usb passthrough from my jantyusa order but, it didn't come with a battery. Would the lithium rechargable cr10430 work with the kb classic? thanks

[Gravity_Tester]

I messed around with where the wire was-different angles, tensions and whatnot, and when I found a spot that worked, I had my darling wife tape the wire into position. A bit more tweaking and I haven't had a problem since. Gotta figure the stuff's made in China, so there are bound to be QC issues (I had a battery that pulled the whole micro-switch out of the battery body simply because I tried to unscrew it from the charger. Had another where the glue failed while I was trying to unscrew the battery from the atomizer-2 dead batts in 3 days. **** happens). Don't be afraid to mess with it a bit, and make sure your supplier is good on customer service...

GT

(I just wish The Smoke Safe was close enough to drive to)