510 NicoStick - 401 Atty as connector

[Paradiso]

Yury, I'm with kLack on this. I've hardly touched my 401 since the 510 has gotten here.
I really like the 401 cartridge design (even though you have to push it up to fill it) and I also like the exposed atomizer. There is no comparison in vapor output and throat hit though.

If you want to make a 401 NicoStick, just pull apart a dead, or dying, battery.

[carr]

Here is my one 401 vs 510.

[four2109]

Interesting how all these different models are just reversed fittings.
Is there a compatability sticky somewhere.
I think the 4081 and 901 are reversed too.

[Paradiso]

Here is my one 401 vs 510.

That's interesting. I took the atomizer completely apart and just used the threaded connector. It looks like you just gutted yours and somehow managed to make a connection to the center post. That must have been hard!

[carr]

That's interesting. I took the atomizer completely apart and just used the threaded connector. It looks like you just gutted yours and somehow managed to make a connection to the center post. That must have been hard!

Not at all, i used a center red wire from the atty as a positive
Just make sure you don’t brake wires when you pull out a coil from the 401 atty.

[ImYourSalt]

"DAMMIT!" Would have tacked a couple M series atomizers onto my last order!

Thanks soooo much for the tip!

[leavitodeaver]

please forgive the noob, how in hell do you get the connector out of an atomizer/battery? i've been banging on this damn 510 battery trying to get the connector out for an hour now and i'm getting pissed. like, hammer and hacksaw pissed. i know i'm dumb, no need to kick me while i'm down 8D.

[bzlytbeer]

If you have a dead atomizer, screw that onto the battery and use it to wiggle it loose and off. If you do not have an atty to use, try vice grips or pliers, but be very careful not to bend it, or bite into it.

[kLAcK]

To disassemble the battery, take a flat head screwdriver and pop off the grey cap where the led is. After that you must grip the other side by the thin gold part. If you twist and pull it will slide out of the black casing.

[brew30]

im new to all this does this mean i can fit a 510 to a 501 bat ?????