Multi Volt Version 2.0

[Shreck]

I swore I would never make another one of these, and this time I mean it.

Its cool though and its mine, so make your own!

Left button, 5 volts. Right Button 6 volts or 3.7 volts, depending on the battery.
Even made just enough room for a little green led in the end cap.
Now with my adapters i made for each different atty, I should be able to use this with them all..






Robert, You keep makin em too,
Cause I'm done!!

[DaMulta]

Is that a washer on top? What buttons did you end up using?

[Robert]

Nice buttons- I might make a few more- but damn it aint easy! Maybe with the 16 led FL?

I think I like the 5v only better.

I got an idea for connecting the common better- drill the case and solder it in- right next to where common connects anyway- solder it all together! filling with jb- permanent ground.

Did you see my video? DIY 5 volt?

[Shreck]

Is that a washer on top? What buttons did you end up using?

Ya, actually its a stainess washer with another smaller washer welded to the backside of it to give the atty a little recess...

[Shreck]

Buttons are 12mm square tactile switches from SparkFun:

SparkFun Electronics - Momentary Push Button Switch - 12mm Square