Video- How to Make a 5 Volt Mod "Detonator"

[smonomo]

In the video Robert briefly mentions the momentary switch from TI, does anyone know the part number for the switch?
Need something smaller than what Radio shack has to offer.

btw, I drill a small hole in the case, and insert a small screw, and solder to the screw for my ground.

[Doctor Vapor]

In the video Robert briefly mentions the momentary switch from TI, does anyone know the part number for the switch?

I agree. Robert, if you could put a parts list together and post it that would be great.

[bigozone]

anybody besides me notice that a quarter fits in the lens hole perfectly??

but i just bought some $0.05 washers and grind them down a touch after drilling out the center holes.

edit: and the idea of grounding to the metal exterior of the switch housing is pretty good.
unless you are using a plastic switch

[smonomo]

I read in an earlier thread that a beer bottle cap fits nice and tight over the end..

now if I could just lay me hands on some smaller switches.

[Uncle Pennybags]

I like this! Very cool mod!

[uzzaperez]

what happened to the vids? all but the first say removed by user if you try and play them?

[Kre8t0r]

Might have to do with the whole "Detonation" incident Robert had a while back...

Flashlight go BOOM!

[chainvapor]

I have one Mod that I purchased, but would very much like to make one like this. Hopefully I will have the time soon!

CV

P.S. Nice videos! THANKS!

[doots]

I have one Mod that I purchased, but would very much like to make one like this. Hopefully I will have the time soon!

CV

P.S. Nice videos! THANKS!

these used cr2s and could have been dangerous to use as robert found out. 16340 could be used but not in these tubes as they are too big.
cr2 protected would work. there are better mods to make..
I still have one that works but you cant get to the switch because of the epoxy dome unless you break it all up to replace the switch or atty connector.