Shotgun mod in a neat case

[opuscroakus]

Edit..Caesar, about the charger. with 2 batteries in parallel would The 1 usb charger top them both off correctly or would you need 2 usb boards for that?

This is a question I have been looking to have answered for some time. Please let us know!

[boondongle]

From what I've read (on this forum, mostly), trying to charge multiple cells requires special equipment to avoid BAD THINGS...like overcharging or overdischarging the batteries. I don't have any experience or practical knowledge personally, though.

[jj2]

How is it when you take a pull of both of them at once?
Talk about vapor.

[vendo]

I see from your other thread you were having trouble with vaping both at once. I'm sure the suggestion of the whistle tip will help but maybe you could try to make a Y adaptor to go over both cartridges like this


By the way GREAT MOD!

[boondongle]

How is it when you take a pull of both of them at once?
Talk about vapor.

It's pretty nice. Vapor production actually isn't as huge as it might be, because I can't quite get a seal with my lips, so I'm also pulling in a lot of air. But it's nice and cool, with tons of flavor.

I see from your other thread you were having trouble with vaping both at once. I'm sure the suggestion of the whistle tip will help but maybe you could try to make a Y adaptor to go over both cartridges like this

That would definitely be a better solution. Hmmm...now I have to think about how on earth I could build one.

By the way GREAT MOD!

Thanks!

[vendo]

That would definitely be a better solution. Hmmm...now I have to think about how on earth I could build one.


Thanks!

How about something like this Tubing Y connector, plastic - Home Science Tools and then just use some of this Tubing, 4.8 mm vinyl, 2' long - Home Science Tools If you keep the tubing as short as possible, only using it to join the pieces, it should not collapse with suction
It may look a bit unsightly but it's a starting point

Edit: You could get the profile /angle of the Y down by heating and bending to the right shape
I did not measure the carts so that Y may not be the right size but just an idea that may help

[boondongle]

Yeah, that tubing is definitely too small, but it gave me the idea to make a Y-shaped mouthpiece out of this stuff.