super_X_drifter;14905362 said:
Thanks for the vid Russ. Long, but covers the Nuppin' quite well and as always entertaining.
A suggestion if I may on making the build way easier... If you follow Peter's suggested premade coil picture that I posted earlier in this
thread, the build is very easy. IOW, negative lead cut to length per his specs, positive lead hooked (to what I eye as in the right proportion to position the coil near the edge of the deck). Even a dual build from these premade
coils only takes me a minute or two to install. When I install I put the negative lead (down leg) in first (straight down and that positions the coil side to side where it will stay), then spin the whole coil to get the positive leg in, lightly tighten the negative lead only to hold it... then install the other coil the same way and finish by tightening all 3 screws. Then I position the
coils level to the AFC height if needed a little and to clear the outside edge of the deck. No fuss, no muss, end up with shorter coil tails from posts to coil(s) and a clean looking build.
Sorry, no pictures of my builds (doubt any of my digital cameras or lighting are up to the task with me running them).
Peter's picture again for reference...