Kanger coil head improved:
First attempt. Tried 4 holes 90 degrees apart. Was close but not exact. 0.91mm at about 45 degree angle.
Needed more air.
Next larger reamer at 1.35mm. Much better.
With gasket installed:
Tools used. These are small dental burrs used to drill teeth. I have a ton of these for PCB repair. I think their official name is carbide burr (tree shape). They rip right
through the chrome plated brass like it is butter. I didn't even need a pilot hole or punch to get the smaller burr started.
Pin air hole measurements:
There is a rather significant difference between the EVOD and Aero coil units. I am not sure why I have two different measurements for my EVOD / T3S heads unless I mixed my 5 originals with my 3 cheapos that came in the T3S heads that I initially purchased when I started
vaping.
Soooo much airflow! This Aero is now hitting like a smaller airflow dripper like my bored out Patriot. WOW!