Posting this in hopes of helping those new to kayfun style Atomizers and Cotton wicking. For those already experienced this may be boring or different from your preferred builds.
This is NOT a coil building tutorial. Each situation, personal preference, setup will dictate your preferred coil build Size, wire gauge, resistance.
The kayfun line, Russian Atomizers and Many similar clones have much to offer the vaping enthusiast. These devices offer much in the way of build flexibility and come in several configurations. Some have fill valves while others are bottom fill. Some offer adjustable air control.
For this build, I will be using one of the least expensive Kayfun Lite Clones on the market ($14) and a Nano kit for reduced size.
View attachment 320783
This unit though not a 1:1 clone offers a lot of performance in an inexpensive package.
Onward we go. First things first - ALWAYS strip and clean any rebuildable device on receipt.
Ready for Ultrasonic Bath
View attachment 320785
15 Minutes later - YUK!!!
View attachment 320786
I have found cleaning is a MUST even if it looks ready to build.
A few good rinses, pat everything dry and we are ready to build.
View attachment 320787
I have found the Kayfun style Atomizers work well over a wide range of resitances and with many different gauge wires and coil layouts. This build will cover one which has consistently worked well for my equipment. Vape quality has been excellent. Vapor impressive. Wick longevity extreme.(40+Ml)
For the coil, I use a basic Nano style depending on use from 1.2-1.8ohm and mount it in line with the channels.
Consistency of coil build and wick volume are key in getting the most out of you Kayfun style device.
I always build using a 14ga. syringe needle = 2mm or 1/16 inch drill bit.
View attachment 320792
To Be continued............
This is NOT a coil building tutorial. Each situation, personal preference, setup will dictate your preferred coil build Size, wire gauge, resistance.
The kayfun line, Russian Atomizers and Many similar clones have much to offer the vaping enthusiast. These devices offer much in the way of build flexibility and come in several configurations. Some have fill valves while others are bottom fill. Some offer adjustable air control.
For this build, I will be using one of the least expensive Kayfun Lite Clones on the market ($14) and a Nano kit for reduced size.
View attachment 320783
This unit though not a 1:1 clone offers a lot of performance in an inexpensive package.
Onward we go. First things first - ALWAYS strip and clean any rebuildable device on receipt.
Ready for Ultrasonic Bath
View attachment 320785
15 Minutes later - YUK!!!
View attachment 320786
I have found cleaning is a MUST even if it looks ready to build.
A few good rinses, pat everything dry and we are ready to build.
View attachment 320787
I have found the Kayfun style Atomizers work well over a wide range of resitances and with many different gauge wires and coil layouts. This build will cover one which has consistently worked well for my equipment. Vape quality has been excellent. Vapor impressive. Wick longevity extreme.(40+Ml)
For the coil, I use a basic Nano style depending on use from 1.2-1.8ohm and mount it in line with the channels.
Consistency of coil build and wick volume are key in getting the most out of you Kayfun style device.
I always build using a 14ga. syringe needle = 2mm or 1/16 inch drill bit.
View attachment 320792
To Be continued............
