E-Cigarette Forum - Elfsong - Blogs
View RSS Feed

Elfsong

  1. Glue/Epoxy used when mounting DNA20/30 board??

    by , 05-13-2014 at 02:17 AM
    Quote Originally Posted by mamu View Post
    I use Versachem gel epoxy to hold the screen and board in place inside the case. If I need to remove the screen/board from the case, I use a heat gun which makes the gel epoxy soft again so it can be pried away with no damage to the screen/board.

    VersaChem 46509 5 Minute Gel Epoxy
    Categories
    Uncategorized
  2. Fool-proof Genesis Technique. Before you sell your Genesis style RBA, read this.

    by , 05-03-2014 at 03:37 AM
    Quote Originally Posted by hubblecraft83 View Post
    I wasn't happy with the commonly filmed coil technique. If anyone new to this is having trouble with shorts and hotspots give this a try. I recommend 500 ss mesh but any mesh will give you good results.

    Hubble's GenTech

    *Make and oxidize a tight dense wick per the http://www.e-cigarette-forum.com/for...0-ss-mesh.html thread technique (no center hole, as tight as it can be. almost the size of your wick hole). Don't go overboard with oxidizing, you
    ...
    Categories
    Uncategorized
  3. Bounce some ideas around for using li-po battery packs.

    by , 04-27-2014 at 03:27 AM
    Quote Originally Posted by bapgood View Post
    Quote Originally Posted by BobC View Post
    Wouldn't change the C rating, and most (if not all) of those batts don't have the amperage to drive a decent coil

    This is wrong.

    Like Tiki said almost any lipo will work, especially RC lipo's.

    To calculate constant amp drain rating of a lipo, divide the mAh by 1000 to get Ah and multiply by the c-rating.

    Here is an example.....let's say we have a 2S 2400mAh 20c lipo pack that we are going to rewire in parallel.

    2400/1000=2.4
    ...
    Categories
    Uncategorized