Entries with no category
Alright, home stretch, and this is the part that's likely relevant to all of you that have rewicked a PT single coil with a Micro and cotton before....Normally, you'd only pull a small bit through, snip it off, and clean up the other side, and perhaps use a small cotton flavor wick on top.... well, in order to recoil a PT3 head into a single, at least in my experience thus far, you need that flavor wick to take up the extra space that the "top coil" in the PT head used to.
...IF all looks good, snip them off either using a pair of fingernail clippers, or you can try the "twist it till it breaks method", but this is a tad bit harder with 28ga wire.
Now on to perhaps the trickiest part of the build, and that's the cotton.... because for every liquid and person, there's a slightly different amount. I tried my best to show the amount I use for this particular build, which works great for my draw style, and
Alright, so, after talking on a thread to one of our members about Protank coils (specifically in relation to Nicoticket's juices, since they seem to prefer lower ohms, I set out to rebuild and lower the ohms on my Aerotank coils, using Cotton and Microcoils.... (I know for a lot of you, rebuilding PT heads is old schools, so you might want to skip down to part three to get to the issue where I take care of the "extra space in the PT3 head)
First things first, Tools: Tweezers,
Updated 02-26-2014 at 11:56 PM by Fenris4024