I was hoping some of you guys can help me with some issues I'm having with my Zmax. I was going to start a new thread, but figured I would get more help here. I've gone through some of the pages in here, but not all (130 is a bit much), so any help would be greatly appreciated.
A little backstyory:
I have been using a PT2
tank since I got the telescoping V5 and constantly got burnt taste, so I would have to bring it down to 7-8w to avoid this using the standard Kanger head
coils (2.4 and even 1.5 ohm coils). I then got into building my own coils and have been using 28 gauge kanthal wire to build them. My current coil is a 1.5 ohm coil with 28 gauge and cotton wick on my PT2 and I also have a IGO-L that's at 1.3.
Here are my problems:
1. Sometimes the fire button doesn't work. It looks like the black button under the fire button is not completely aligned. Is there a way to fix this?
2. When I try to get up to the higher wattage (11W+), the mod and the
tank get really hot. Last night when using the IGO-L (the PT2 as well) at 12W the top cap got so hot I had to wait a little while before touching it to take off. What can be causing this?
3. As the battery gets drained, it automatically lowers the wattage output on me. Isn't the purpose of the VW to keep it consistent until the battery is fully drained?
4. If I'm trying to get to higher wattages (i.e. 11W+), what resistance would you recommend? I bought what I was told was a 30 gauge Kanthal to build some 2.0-2.4 ohm coils to try out, but with 9-10 wraps, it reads out to 3.4 ohms. That and the fact that the wire seems considerably smaller than the 28 I have, makes me think that it's a 32 gauge.
Thanks for your time!