Decided to go with just a bit more kgd this time, since more did work better before! I'm having very good luck de-skinning both sides of my kgd and just starting with a wider strip than if only de-skinning one side. I also gently roll the kgd using my pant leg. I've noticed that when using with only one side skinned, the skin was folding and bunching as I pulled it through the 2.25mm id coil. I feel I get better uniformity of wick through the coil this way. Had to stretch it to get it to slide back and forth in the coil; then carefully trimmed so it brushed the rba floor. Wet thoroughly, then brush back wick from
juice holes with a toothpick. Install chimney with care not to move wick, primer puff or two looking for bubbles and vape!
I can hit this from 3-5 seconds chain
vaping anywhere from 15-30W at 0.8Ω. Best wick so far with this coil! Thick, rich, flavor-filled clouds each and every hit...
tank after tank!