Lonnie Lepp

Originally Posted by Lonnie Lepp

Where did you get that awesome white box?

Looks like you used a router from the inside of the box to make a recess for the volt meter to shine through the box's side.

Very Nicely done.

Lonnie

Originally Posted by WillyB

Seems like a very awkward place to put a fire switch.

Even worse than this awkward position.

Originally Posted by Wooden indian

Made a few from this Digikey design. These little square flashlights make a great body.



First I removed the LED board, battery terminals, and plastic screw holes.



Then, I use painters tape top secure the box together and a sharpie to mark my holes.

...

Originally Posted by bstedh

Originally Posted by WillyB

Well some credit should go to the very modest CapeCad who was first to use this chip back in 8-2010 in a mod and again in another in January.

Absolutely Positively...

This chip was recommended to me when I was working on my VVeller.

Here are some referenced past posts.
http://www.e-cigarette-forum.com/for...e-voltage.html

http://www.e-cigarette-forum.com/for...regulator.html

...

Originally Posted by bstedh

I thought I would share my research and post an easy VV that just about anyone who can use a soldering iron could put together.

A lot of this came from the evercool thread and work on my own VV. http://www.e-cigarette-forum.com/for...ltage-mod.html

I did not include a box or other body as you can put this into whatever type of mod you can cram it into...

You can also add an LED or other bells and whistles but I wanted

...

Originally Posted by bstedh

I thought I would share my research and post an easy VV that just about anyone who can use a soldering iron could put together.

A lot of this came from the evercool thread and work on my own VV. http://www.e-cigarette-forum.com/for...ltage-mod.html

I did not include a box or other body as you can put this into whatever type of mod you can cram it into...

You can also add an LED or other bells and whistles but I wanted

...