super_X_drifter;12087329 said:Heating and squeezing either before or after wrapping was 15 minutes ago
Here's an even easier way to do it without pliers and heat and produce a tighter micro
Micro Coils 101 - Part One - Making The Tightest Coil You've Ever Made - YouTube
Here is the mounting process and hot leg elimination :
Micro Coils 101 - Part Two - Mounting The Coil In A Bottom Fed Or Dripping Rebuildable Atomizer - YouTube
And here's the wicking :
Micro Coils 101 - Part Three - Wicking And Vaping - YouTube
Sup just wanted to take a minute to thank you publicly for your truly exceptional effort above.
As you may by now know a few of us have been the past 4 months building a modest gateway to transition newcomers to rebuilding using microcoils on M_DuBb716's thread Protank MicroCoil Discussion!!.
A good part of this for me has been trying to broaden the science and mechanical principles being applied to get new vapers there faster. After lurking for some time and a multi-month-long journey that is the odyssey of ECF's pages I picked up at metalhed73's great basic localization thread Protank Cotton Rebuild, the way I do it which began to detail the essentials of proper electrical symmetry for the Kanger ProTank.
So you have only yourself and these two bums to blame for getting me mixed up in this mess.
I wanted once again to express my gratitude for considering the mechanical principle of tension and adaptation to tighter builds with the proper objectivity and the curiosity of a wild man.
And of course, for putting these great videos together around it.
You are a scholar and a gentleman.
Good luck.
