zmauls;11539103 said:crazyarms;11536779 said:Looks like maybe 1/8th inch or a hair smaller? I need to sand down my reo. How is everyone sanding it? Dremel?
Mine is 1/8", yes. On both sides. I run a dual coil at 0.3ohm. Though, I am a cloud chaser... my flavor is excellent, but I understand that most people don't hit their e-cigs with their lungs like I do.
As for sanding, and this is was recommended to me by the man himself:
Use one of the 510 connectors (hopefully you have one). Attach it to your RM2. Then, close your drill's mouth onto the 510 connector tightly. With 200 grit sandpaper in-hand, pull the trigger and let the drill do the work.
Sanding a RM2 to a brass finish!
- Author mwdenko
- Create date
Blog entry information
More entries in ECF Blogs
-
Beware of These Sketchy Online Vape ShopsThis blog post is a work in progress... Over the past year or so I've... -
Uwell Caliburn G3 Pod Kit ~ A Review By AngeNZUwell Caliburn G3 Pod Kit ~ A Review By AngeNZ Introduction: Uwell... -
18650 Battery Ratings and Performance TableYou are responsible for your own safety! These batteries are designed... -
I can't taste my aroma anymore, how can I increase it to taste it again?Scenario I made an e-liquid in a 60 ml bottle with 8% of flavor and...
