Old i Clear 30 modification

Nicotinologist;11164293 said:

rushman;9465269 said:

I was wondering if anyone had attempted to mod an iclear 30 for an easier pull. I'm not looking to make it hit like a kanger, but somewhere in between would be perfect.

Thoughts? I think I'll try enlarging the air holes just above the threads if anyone thinks that would work.

Click to expand...

Yeah, I've done all 3 of mine. I was going to throw them all away, but I decided to experiment on them. Here is the procedure:
1. Disassemble the atomizer and wash and dry.
2. Unscrew and the replaceable coil assembly.
3. Remove by pushing the bottom center pin of the base from the top.
4. Drill a hole using a 1mm or 1/32" drill bit as close as possible to the channels on both sides. Make sure to position the 2 holes without drilling the rubber seal.
5. Carefully trim the upper silicone cap seal very squarely and flat 1mm or 1/32".
6. Enlarge the center pin top hole to the next available drill size.
7. Clean everything and make sure you do not have any metal shavings on the base that may cause shorts

If you happen to have the new version of the iClear30s, use the i Clear 30s upper seal or order one or the minimum replacement coil atomizer for it. These modified old i Clear 30 are 100% better than the new version.

Click to expand...