510 Connector and Drip Well Suggestions for Bottom Feeder

SammyT;6358377 said:

Reo setup is one 6ml bottle with this http://www.theoringstore.com/index.php?main_page=product_info&cPath=23_22&products_id=1109o-ring in the cap, http://www.theoringstore.com/index.php?main_page=product_info&cPath=23_22&products_id=1069for a 3ml bottle. The bottles can be found at http://shop.perfumersapprentice.com/c-110-accessories.aspxThe tubing is available at us plastics. It is the 1/16 id 3/16 OD 1/16 wall. http://www.usplastic.com/mobile/item.aspx?itemid=23278&catid=799 to make the hole in the bottle cap use a 11/64 bit.

Gabe when I make my bottom feeder center posts I use a cheap RCA jack prong. They are filled with plastic. I drill it out, drill through the tip with a 1/16 bit and then put some lead free solder in the open end. Then I use one of the posts you have used, and drill out where I soldered to barely fit the center post. Then I heat up the metal to make the bond. The end may need some shaping to accept the tubing but I find this gives me plenty of room to solder pos wire. Good luck


-Sam

Click to expand...