1wildman;12933139 said:Vapz1;12931975 said:Very Nice!
I'm new to building coils and I bought an IGO W3 sold on the fact that it was great. Adviser failed to mention how tough it is the build a 2 let alone a 4 coil build. Tried 1 coil and it was OK but note to self...don't use 12mg nic juice...Knocked me on the floor. And I have to admit I was expecting tons of vapor. Does the MVP work well with these rebuildables? If you build a 1 ohm coil isn't that like 25 watts @ 5.0V? I was thinking that would put out some great vapor.
I need a tudor! LOL
Quads are a pain on most even a 5 post setup. You won't be able to build anything with quad coils that will work on an MVP well. Two should not be a problem hardest part is two wires through center and clipping the legs against the post.
Vapor is also a function of air flow so depending on your build you may need to open that W3 up by drilling air holes. I think I drilled my W3 out to 1/16. Start smaller and work up cuz you can't un drill a hole.
The MVP limit is 11w regardless of voltage. Yes 5v @ 1Ω is 25 watts. I use a mech mostly for dripping so max is 4.2v on at would be 17w. That is why I build at 0.5 ohms.
That being said you should be able to build two 2Ω coils for a total 1Ω build and run it at 11w on the MVP and get an enjoyable vape. It should put out more vapor than any clearo you can get for the MVP.
Blogging this for future reference for my A6 and RSST and future toppers.