Originally Posted by 1wildman
Originally Posted by Vapz1
I'm new to building coils and I bought an IGO W3 sold on the fact that it was great. Adviser failed to mention how tough it is the build a 2 let alone a 4 coil build. Tried 1 coil and it was OK but note to self...don't use 12mg nic juice...Knocked me on the floor. And I have to admit I was expecting tons of vapor. Does the MVP work well with these rebuildables? If you build a 1 ohm coil isn't that like 25 watts @ 5.0V? I was thinking that would put out some great vapor.
So many questions, so much misinformation - and all it will take to clear up at least 80% of both... is a bit of knowledge.
This isn't going to be a class in all things Ohm's Law, so much as a few things you need to know about resistance and power... so that both your vape and your safety is well considered. First... lets open up a very easy to use, uncluttered with BS, on-line Ohm's Law calculator, or 'OLC'. Got it? Good.
Most common misconceptions I run into are:
Updated 05-21-2014 at 10:51 PM by State O' Flux
This weeks Discounts:
Four Flavors this week 12ml for 50% off - Shipping $3
Cookies & Cream
No longer need a coupon code for the flavors of the week.
30ml for $10 - Shipping: $3.95
The Vapor Room
$10 for 30ml shipping $4
Updated 04-29-2014 at 03:33 AM by cleolove
(the smoothest Bailey's shake)
0.5% FA Irish Cream
0.5% FA Caramel
0.5% FA Fresh Cream
0.5% FA Vienna Cream
Mix well and vape - no steeping required.
For a super-fast batch with less measuring, just add 1 drop of each flavor to 6ml of nic base.
The 2% total flavoring is light but just right to my tastes; I use an EVOD on an eGo. Using 0.75% of each flavoring for 3% total flavoring is also delicious. 1% of each flavor for double-strength will
Updated 06-03-2014 at 03:13 AM by HeadInClouds
Originally Posted by Vwls
Originally Posted by Cman1337
I use a SS Quasar by Cosmic innovations with 6 wraps of 24 guage wire. Comes out to 0.190 ohms.
WAT. Don't go that low. It's not needed and there are a laundry list of reasons not to including battery safety, acrolein production, etc.
Originally Posted by Striknine
Just purchased an Igo-T and would like to try out dripping in lieu of using a tank. How many wraps and what gauge does everyone recommend for a single or double coil build?
I have been using a kayfun for the last month with 12 wraps of 28ga.