E-Cigarette Forum - Blog Entries - Blogs
View RSS Feed

All Blog Entries

  1. DNA40 and NI200 Wire

    by , 10-13-2014 at 07:49 PM
    Quote Originally Posted by David1975 View Post
    My last question is on the NI200. I understand this is non-res wire, sooooooo possible stupid question to follow How do we measure resistance when making a coil? I understand the board may read it, but as is, will an Ohm meter or multimeter still work with this or is it simply not that important anymore?
    OK NI200 wire.


    First, lets dispel the NR myth, there is NO SUCH THING as Non-resistance wire! ALL wire has resistance, even so called super-conductors cooled ...
    Tags: dna40, evolv, ni200
    Categories
    Uncategorized
  2. DNA40 fusing

    by , 10-13-2014 at 07:45 PM
    Quote Originally Posted by David1975 View Post
    I would like to know about fusing this board as well. If it does need/ should be fuse, will the DNA30 fuses work or do we need another type/size?
    The board has:

    • Over/under Voltage protection
    • Over Current protection
    • Reverse polarity protection.

    So the board will protect itself no matter what you throw at it. The board itself does not need a fuse.

    HOWEVER, the battery is not protected. If something in your Mod (like a broken wire) creates a dead ...
    Tags: dna40, evolv, fuses
    Categories
    Uncategorized
  3. The DNA40

    by , 10-13-2014 at 07:42 PM
    Quote Originally Posted by mikepetro View Post

    Ok folks, I have been given the go ahead to open my mouth as of midnight. We were all told to wait until Phil Busardo posted his video,

    As most of you know, I have been on the Evolv beta Team for this one and I have been testing the unit for several weeks. It has become my "go to" mod without doubt. By dialing in the temp to suit my juice and coil combo, I then get very repeatable hits, and no dry hits ever, even when dripping.

    The new DNA40 from Evolv
    ...
    Tags: dna40, evolv, ni200
    Categories
    Uncategorized
  4. show off your mech! homebuilt mods only!

    by , 10-12-2014 at 07:53 PM
    Quote Originally Posted by vapero View Post
    I guess I'll trow in my mods here!








    for future reference ...
    Categories
    Uncategorized
  5. Broke My VV V3 Today :(

    by , 10-12-2014 at 03:50 PM
    Quote Originally Posted by atroph View Post
    Went outside to have a vape and set my mod with dripper attached on the railing around my front porch. The thing rolled off the railing and hit the concrete right on the drip tip. Went to fire it and nothing. non on the display. Pulled the center pin to see if it was still connected and it pulled right out.

    Time to take it apart.

    The little rivets that are on the sides are actually pins with knurling at the top to keep them in. I have a rather sharp pair of flush cut wire
    ...
    Categories
    Uncategorized