E-Cigarette Forum - Blog Entries - Blogs
View RSS Feed

All Blog Entries

  1. How I Prime BVC Coils

    by , 12-23-2014 at 01:51 AM
    1) fill the tank and note the level as accurately as possible

    2) use my fingers to block off all (or most) of the airflow. Then take hits to create vacuum and fill the coil.

    3) you should see air bubbles escaping from the holes in the coil as it takes on juice. Continue to do so until the air bubbles stop.

    4) go back and check the level of the tank now (it should be 0.25 to 0.3ml lower than when you started). Sometimes I end up flooding them in the process, ...
  2. Dec 22 / 2014 - Still Quit !!!

    by , 12-22-2014 at 01:48 PM (Mark Andersen - eCig Blog)
    I haven't had a stinky in 113 Hours and 50 Minutes.
    Categories
    Uncategorized
  3. Official ProVari 3 Thread - P3 - The Difference between VV and VW - Explained~!

    by , 12-22-2014 at 06:40 AM
    Quote Originally Posted by The Ocelot View Post
    Quote Originally Posted by rbrylawski View Post
    With my pea-sized brain, I figured that if the ohm of the coil is less (or more for that matter), the wattage would need to be adjusted to produce the same vape. I see the volts did indeed go down, when I usually vape on a 1.8 ohm coil, the volts usually show 4.4. But on the 1.6 ohm coil, the volts now show 4.2. Still not a very big difference, but I guess the volts vs watts difference is still somewhat lost on me.
    Oh my... perhaps I can make it easy (though I am sure others have
    ...
  4. Approximate temp based on glow color

    by , 12-21-2014 at 10:00 PM
    Quote Originally Posted by Woofer View Post
    Perhaps this helps Temperature of a "Red Hot"Object
    Temperature of a "Red Hot"Object
    Color Approximate Temperature
    F C K
    Faint Red 930 500 770
    ...
    Categories
    Uncategorized
  5. Dec 21 / 2014 - Still Quit !!!

    by , 12-21-2014 at 04:16 PM (Mark Andersen - eCig Blog)
    It's been 92 3/4 hours since my last smoke...
    Categories
    Uncategorized