E-Cigarette Forum - Blog Entries - Blogs
View RSS Feed

All Blog Entries

  1. How to Make Fruit Danish eJuice - Recipes from the Flavorthon

    by , 10-18-2014 at 08:18 PM
    Quote Originally Posted by Bill's Magic Vapor View Post
    Quote Originally Posted by Bill's Magic Vapor View Post
    It's the combination of flavors that does the trick, and in the right proportions. This takes experimentation, trial and error. Too much flavoring is often NOT the problem. Often times it is too little flavoring, or not having the right mix. Think about it this way. Sweet cream is cream and sweet flavor. Even if you use Sweet Cream, you may still have to add Sweetener or Cotton Candy (Ethyl Maltol). You need both to get sweet cream. I start with the fruit at recommended starting percentages and
    ...
    Categories
    Uncategorized
  2. Taifun GT Discusion!

    by , 10-17-2014 at 09:56 PM
    Quote Originally Posted by dwcraig1 View Post

    Note: 11 x 1 mm on most, 12 x 1 mm on some (under sliding sleeve)
    I've heard that on some clones that the chimney is pressed into the tank top, most are one piece.
    Categories
    Uncategorized
  3. Tesla 2Six Magnetic Switch mod

    by , 10-17-2014 at 06:51 PM
    Tesla 2six Style Clone, Magnetic Switch Mod

    Here is information about modding a Tesla 2six clone to use magnets instead of springs. If you have an authentic Tarsius Customs 2six, or a 1:1 clone, this will not work, because the design of the button is different. I also modded a 1:1 clone, but I had to make significant changes to the button housing to get enough throw for it to work. Here's a picture of the 2six I was working with:
    ...

    Updated 10-18-2014 at 08:30 PM by PapaSloth

    Categories
    Uncategorized
  4. BSD's vertical hollow core Micro Coil build for ARO, Evod, and Protank heads.

    by , 10-17-2014 at 06:03 PM
    Great pictures of protank vertical coil build

    Quote Originally Posted by Big Screen D View Post
    OK. I was wrong. Forget everything I've written up to this point. Well almost everything lol.

    Intuitively, I always assumed that the coil needed to be a micro coil in order to create a airway, or as this type of vertical coil is often referred to "chimney". Not only does it not have to be a touching coil, this spaced vertical coil blows the touching coils out of the water! Flavor and vape production
    ...
    Categories
    Uncategorized
  5. O-Rings for Taifun GT

    by , 10-17-2014 at 04:31 PM
    TAIFUN GT O-RING SIZES
    17 x 1.5 are at each place where the end of the tank seals..

    12 x 1 mm on the chamber cap.
    11 x 1 mm or 12 x 1 mm under the sliding sleeve.
    4 x 1 on the end of the chimney (fill line).
    2 x 1 mm under the 510 screw's head.
    5 x 1.5 mm goes on the drip tip
    Buna or Nitrile

    Here's where I buy mine:
    http://www.oringsandmore.com/
    Note: 11 x 1 mm on most, 12 x 1 mm on some (under sliding sleeve)
    I've heard that ...

    Updated 10-18-2014 at 03:12 AM by dwcraig1

    Categories
    Uncategorized