E-Cigarette Forum - Blog Entries - Blogs
View RSS Feed

All Blog Entries

  1. Micro Coil for the RBA on your REO

    by , 07-30-2013 at 04:13 AM
    Quote Originally Posted by ukeman View Post
    holy crap! thats tiny... in mm increments how do you get the cotton in there?
    Quote Originally Posted by super_X_drifter View Post
    Here's some pix:
    These are the needle selections. Left to right.
    16ga, 17ga & 18 ga. I used the middle white 17 ga.


    That's a scale with millimeter increments.
    Categories
    Uncategorized
  2. Micro Coil for the RBA on your REO

    by , 07-30-2013 at 03:25 AM
    Quote Originally Posted by ukeman View Post
    holy crap! thats tiny... in mm increments how do you get the cotton in there?
    Quote Originally Posted by super_X_drifter View Post
    Here's some pix:
    These are the needle selections. Left to right.
    16ga, 17ga & 18 ga. I used the middle white 17 ga.


    That's a scale with millimeter increments.
    Categories
    Uncategorized
  3. The beginning of freedom.

    by , 07-30-2013 at 02:39 AM
    I started smoking a bit over 30 years ago when I joined the Army. Smokers got two extra breaks back then.
    After Basic Training, I switched to a pipe because I liked the flavor better.
    Then after 25 years, I was waking myself up with that wheezing sound you get lying on your side and had to sit up and cough really hard to clear it out.
    I started looking to quit or switch to something else. Heard about e-cigs, but e-pipes were expensive and didnít work well. October 2012, I started ...
    Categories
    Uncategorized
  4. innokin svd activation button not firing consistently

    by , 07-30-2013 at 12:21 AM
    Quote Originally Posted by paulc35 View Post
    I've had the SVD for a week. Everything has been great up until today. Using AW IMR 18650 and efest.
    When I go to press the power button it fires and then every 3-5 button presses it doesn't respond. I look down and no green light. Release and press again it fires and light is green. I've switched from tanks to cartomizers, I-16,I-30, boge Cartomizers. Problem occurs with any type used.


    Any thoughts
  5. Review Time! Innokin iTaste 134

    by , 07-29-2013 at 05:15 PM


    Here's my review of the Innokin iTaste 134, including an explanation from the company on why it doesn't have a resistance (ohm) reader. Check out the full text review here.
    Categories
    Uncategorized