E-Cigarette Forum - Blog Entries - Blogs
View RSS Feed

All Blog Entries

  1. My Comments to the FDA

    by , 08-05-2014 at 11:28 PM
    Here's what I wrote to the FDA on their regulation.gov site:

    I smoked cigarettes for 30 years, a pack a day and sometimes more. I hated them. The cost, the smell, the enormous amount of waste produced. I tried multiple times to quit, to no avail. The patch, the gum, even cold turkey. Nothing worked. I tried Blu, and it was awful. It lasted less than a week. The flavors were terrible, and having to recharge the battery every hour or so was just impossible. I went back to smoking ...
  2. Older Folks and Vaping Back Porch - Part 2

    by , 08-05-2014 at 05:55 PM
    Quote Originally Posted by Slots View Post
    Quote Originally Posted by 2legsshrt View Post
    Well I jumped in with both feet. Got another Provari another Kayfun.Wife finally got one she likes FA 7 leaves mixed at 1.5% for me so far it FA Maxx Blend at 3% and the RY4 from Mike and Janet. Still looking for a 3rd that I like as well.
    Hi 2legs ... how's it going on Camano ??

    Opinions of the FA tobaccos I tried.....each solo, as a test
    Mellow Sunset[ = SUPER soft flavor, clear juice, no real taste at 2%, will try at a higher % next time.
    Tuscan Reserve
  3. My comment to the FDstupidA

    by , 08-05-2014 at 05:39 PM
    From: Andria Duncan
    To: FDA Center for Tobacco Products
    RE: FDA, Docket No. FDA-2014-N-0189, Regulatory Information Number (RIN) 0910- AG38

    I smoked for 39 years, anywhere from 3/4-pk a day, all the way up to, at one point, 3 pks a day. I tried to quit at least 4 times, either cold-turkey or using "the patch," but all I ever managed was to cut down on smoking; I never could entirely quit -- until I found e-cigarettes. I first quit using e-cigarettes in Feb ...
    Tags: comment, cta, fda
  4. (15) Inexpensive Mechanical Mod/RDA Setup

    by , 08-05-2014 at 04:56 PM
    Many vapers are asking the best way to get into dripping on a mechanical mod and RBA without breaking their bank account. I've carefully chosen the following recommendations based on my experience which can provide an inexpensive quality setup, and added suggestions for the tools & supplies needed to make coils.

    The Silver Bullet and IGO-W were my first mech mod and rebuildable drip atomizer which I still use on a daily basis. I'm using a dual microcoil build @ 0.6 ohms with ...

    Updated 09-22-2014 at 09:50 PM by Baditude

  5. Part Deux - For the advanced education of mech and RBA users...

    by , 08-05-2014 at 03:02 AM
    I've exceeded the 10K character limit in part one... so, here's part deux!

    > 2-17-14 Addendum: A coil calculator, developed by ECF member Dampmaskin and called "Steam Engine" (previously called "vape calc") has become available.
    It includes not only an ohms law calculator, but a coil wrap estimator that includes parameters like ID, target resistance, leg or "tail" length and variable coil counts... and a battery drain calculator as well. ...

    Updated 10-27-2014 at 02:54 PM by State O' Flux