E-Cigarette Forum - Blog Entries - Blogs
View RSS Feed

All Blog Entries

  1. The Stardust center post is no longer centered "OR" the tube is leaking fix.

    by , 12-07-2012 at 04:31 PM
    This is for V3 units but may loosely apply for earlier versions also...

    Found that after the unit got torqued a bit, in my pocket, I noticed that the center post
    was no longer lining up nicely with the drip tip. I discovered that replacing the tube
    was the remedy for this but on further inspection of the "problem" tube I observed
    an uneven gap at the base of the tube, between the metal ring and the indent in the polycarbonate tube. (tube only, not the ...

    Updated 12-13-2012 at 04:04 PM by Hitmetwice (For v3's)

    Tags: fix, leak, stardust, tube
  2. Поговори сам с собой, набей нужное кол-во п&#1

    by , 12-07-2012 at 12:55 PM
    Quote Originally Posted by Suravi View Post
    И все-спираль готова, без скруток.
    Все выше описанное придумано не мной.
  3. dang

    by , 12-07-2012 at 08:58 AM
    [B]i see hoosier ecig supply has dekang cuba cigar-i must have! i love that pg juice. right now for my pg juice i am using havana, not dekang, i dont even remember where i purchased it from-letting my goodejuices steep...[/B]
  4. Rubberized (plastic) Bolt and its weakness Part 2

    by , 12-07-2012 at 06:35 AM
    More pics

    Click image for larger version. 

Name:	DSC_0891b.jpg 
Views:	275 
Size:	19.6 KB 
ID:	157980Click image for larger version. 

Name:	DSC_0894b.jpg 
Views:	210 
Size:	20.3 KB 
ID:	157981
  5. Rubberized (plastic) Bolt and its weakness

    by , 12-07-2012 at 06:32 AM
    So we broke one of our bolts. This is the plastic rubberized version, which is a one piece tube sized for an 18650. It has been pretty clear from the beginning that the 510 connection is loosely set in the device, as a tank will eventually develop a lean. I feared it would eventually fail, and it did. Basically, if you tighten anything tight enough to put any pressure on the 510 connection in a twisting manner, it will bend or break the internal plastic form that holds it from spinning. Once it ...