E-Cigarette Forum - Blog Entries - Blogs
View RSS Feed

All Blog Entries

  1. The DNA40

    by , 10-13-2014 at 07:42 PM
    Quote Originally Posted by mikepetro View Post

    Ok folks, I have been given the go ahead to open my mouth as of midnight. We were all told to wait until Phil Busardo posted his video,

    As most of you know, I have been on the Evolv beta Team for this one and I have been testing the unit for several weeks. It has become my "go to" mod without doubt. By dialing in the temp to suit my juice and coil combo, I then get very repeatable hits, and no dry hits ever, even when dripping.

    The new DNA40 from Evolv
    Tags: dna40, evolv, ni200
  2. show off your mech! homebuilt mods only!

    by , 10-12-2014 at 07:53 PM
    Quote Originally Posted by vapero View Post
    I guess I'll trow in my mods here!

    for future reference ...
  3. Broke My VV V3 Today :(

    by , 10-12-2014 at 03:50 PM
    Quote Originally Posted by atroph View Post
    Went outside to have a vape and set my mod with dripper attached on the railing around my front porch. The thing rolled off the railing and hit the concrete right on the drip tip. Went to fire it and nothing. non on the display. Pulled the center pin to see if it was still connected and it pulled right out.

    Time to take it apart.

    The little rivets that are on the sides are actually pins with knurling at the top to keep them in. I have a rather sharp pair of flush cut wire
  4. MVP Owners Group-into the next generation…

    by , 10-12-2014 at 03:25 PM
    Quote Originally Posted by JimmyDB View Post
    If you want the batteries to last as long as possible, then keep the voltage low.

    I think Table 4 puts it best...
    How to Prolong Lithium-based Batteries - Battery University
    Quote Originally Posted by http://batteryuniversity.com/learn/article/how_to_prolong_lithium_based_batteries
    Charge level Discharge cycles Capacity at full charge
    4.20 300 – 500 100%
  5. Updated Peanutbutter recipe

    by , 10-12-2014 at 02:19 PM
    Peanutbutter cookie is my all day, everyday vape. I've changed the recipe from what is posted below.

    I have bottles (that I get free from where I work) they hold around 45ml. I squirt in 4ml of FA cookie, 2ml of TFA Peanut Butter, 1ml of TFA bavarian cream and a few drops of sweeterner flavor. Then I fill the bottle with my "base" .... 50/50 12mg. It's excellent!

    Since I use bavarian cream in everything I make, I decided to try it alone. I used 10% TFA ...