E-Cigarette Forum - Blog Entries - Blogs
View RSS Feed

All Blog Entries

  1. Officially turned another year older andl lost a friend, who may have never been a friend!

    by , 10-31-2010 at 01:41 AM
    So my birthday to day, turning well............let's just say closer to 60 than to 20.

    I check facebook and all my peeps have sent a happy birthday note, so nice of them. But one peep is missing.

    A peep I thought was my friend. Then I find a message from her, on facebook, dated October 27th,2010 that says "Glad to see that the USB hub I sent you meant a lot to you. I wish you the best and hope you have a great life."

    I gave that usb port away ...
    Categories
    Uncategorized
  2. Vg PG Allergies (misconception that all ejuice and flavors are PG)

    by , 10-30-2010 at 10:50 AM
    The more I talk to others vapors I find a lot of people have some allergic sensitivities to PG.
    It's pretty confusing especially if you are new to vaping .
    The forums are great places for info if you can find it..not always so easy
    uff..I just replied to posts and they went all in the wrong places.

    There seems to be some misconception that all ejuice and flavors has PG.
    I just think its more common that it's used.
    The PG Free resources are out there they ...
  3. Refurbishing A Working But Real Old Nasty 510 Cartomizer pt 6 of 5 (oh shut up)

    by , 10-30-2010 at 07:10 AM
    [QUOTE=Mark Linehan;2100784][ATTACH=CONFIG]21876[/ATTACH]
    ..and there is my nice refurbished/rebuilt carto (repaired even if needed as well)
    [ATTACH=CONFIG]21877[/ATTACH]
    Now you want to take a paper clip and feed it through the air hole like you did with the sewing needle. VERY SLOWLY. VERY CAREFULLY. You will probably have to work it around a bit. Take your time, it will find the way eventually, and then you are sure you have an air stream. If you flat out can not get it through ...
    Categories
    Uncategorized
  4. Refurbishing A Working But Real Old Nasty 510 Cartomizer pt 5 of 5

    by , 10-30-2010 at 07:10 AM
    [QUOTE=Mark Linehan;2100776][ATTACH=CONFIG]21871[/ATTACH]
    Now you start stuffing the innards back into the tube. Notice the little tool I am using. This is a homemade feat of technical prowess and mastery. Ermm.. Well, it is a paperclip with a dab of solder on the end and the solder is flattened out well so it make a small blunt blade for stuffing wayward filler into the carto tube as needed. :)
    [ATTACH=CONFIG]21872[/ATTACH]
    Now get the carto started onto the connector and make ...
    Categories
    Uncategorized
  5. Refurbishing A Working But Real Old Nasty 510 Cartomizer pt 4 of 5

    by , 10-30-2010 at 07:09 AM
    [QUOTE=Mark Linehan;2100760][ATTACH=CONFIG]21863[/ATTACH]
    Now wrap that rectangle of cloth around the coil again from the center of the rectangle and make a two layer wrap around. Keep the tube at the top of the carto, and remember that this has to be the air way through the carto, so when wrapping, keep that in mind. Wrap as though you were leaving a tube in the middle of the cloth material. The top tube, the coil(lump heh) and the bottom connector tube all help form the airway in the middle ...
    Categories
    Uncategorized