Another PTB Mod
by, 11-11-2009 at 07:13 PM (1961 Views)
I wanted to make a quick PTB mod after wasting half a PTB in an attempt to make a 510 cartomizer (didnt work).
I am still using the FRF PTB mod but this is what I have in my 'pipe' right now.
I took a half PTB rolled it long way.
Folded it in half and placed into an empty mod with the fold sticking out the top.
I bent the PTB over the top of the cart on either side.
Removed the PTB from the cart then folded it at the crease making an M shape.
Filled the cart with about 15 drops.
Placed the Mod in the cart.
Added a couple more drops until topped off.
It works really well. Basically the folds on the top act as a plug while leaving room for the atty bridge. The outside folds remain on either side of the bridge when the cart is attached. For this time I did not fray it even though it probably would help in the directional wicking.
Vapor, Taste and Throat Hit is comparable to the FTF Mod.
One of the down falls is refilling. Since you cannot see when it is filling up as with the FRF mod what I have to do is stick the end of the dropper against the top of the mod and squeeze to get some juice in the cart (dropping works too) then drop until i see some liquid pooling on the top.
One of the advantages is the shape. It does not change as the FRF mod does. When you remove the cart the shape is what it is. Almost looks like lips. Another big advantage is, because it is more of a plug, there is no leaking.
Hope this helps