Fogger V2 Vertical Coil and Cotton Ball Wick Part 2
by, 11-06-2013 at 03:54 AM (4837 Views)
Measuring the length needed for the positive coil leg:
Positive coil leg cut to length:
Positive coil leg inserted into post (notice the wire ends halfway through the post), negative leg wrapped around paperclip:
Both post screws installed, tweezers used for pushing coil down close to the deck:
Beginning to install wick, making sure to get some under the top (negative) coil leg:
6 drops of e-liquid:
Wick mostly poked back inside the deck. The easier way to get the clear o-ring in place:
Tiny bubble after a draw, sometimes the bubble is much bigger:
This is my 4th vertical coil build on the Fogger. This time the coil came to 1.16 ohm.
IMO, it works best on a mechanical mod or using a Kick 2 at 14-15 watts.
I am new at this, please feel free to leave comments and/or suggestions.
Thank you for viewing, I hope it's helpful.