Received my kayfun Mini 2.1 today. Played around with it a bit. Thought I'd put up some pics to help anyone with the different configurations. It's beautifully designed. Tried it in dripping mode set up and normal mode. I set it up for 0.9 ohms with 30g Kanthal A-1 on a doubled over ekowool wick. At first, in normal mode, juice leaked out of the air hole but adjusting the air adjustment screw did the trick for me. If it's screwed in too far, it'll touching the center pin. Other causes of leaks can be due to the filling valve. Can clean the valve by flushing it with water using the bottle in the kit, making sure liquid can go in but not come back out. When setting up the coil, had to lift the coil a little bit and make sure it wasn't too low on the air duct. Note: The manufacturer suggest that the coil should run diagonally between the screws across the air duct, the tails of the wicks down the post then above the grooves but not in the grooves.
Stats:
Drip mode holds 20-25 drops (34 mm in length), Standard mode holds 2.8 mls (60.5 mm in length) and Long mode holds 6.0 ml (82 mm in length).
Here are some pics:
View attachment 193097 Full kit (no wire came with mine.. bleh)
View attachment 193098 Dripping mod
View attachment 193099 Normal Mode
View attachment 193100 Long Mode (You can also do variations by switching tank places)
View attachment 193344 How it looks on my Poldiac.
Stats:
Drip mode holds 20-25 drops (34 mm in length), Standard mode holds 2.8 mls (60.5 mm in length) and Long mode holds 6.0 ml (82 mm in length).
Here are some pics:
View attachment 193097 Full kit (no wire came with mine.. bleh)
View attachment 193098 Dripping mod
View attachment 193099 Normal Mode
View attachment 193100 Long Mode (You can also do variations by switching tank places)
View attachment 193344 How it looks on my Poldiac.