How to fill a Carto

These are instructions for filling a carto for people who have never vaped before:

The easiest method to fill a cartomizer is to simply remove the white plug at the mouthpiece end and drip a few drops of e-liquid into the filler material at a time. Be sure to hold the cartomizer at an angle as liquid dripped into the center tube will leak through to the battery connector. Repeat the process until the filler material no longer absorbs liquid.

Use two hands, hold it at an angle like this with your other hand, and drip the liquid into it, This is leaned on the cap only for taking a photo.
carto_MP_fill_01_400.jpg


Put in 3-5 drops, wait for it to absorb, then put in 3-5 more drops, until either some juice leaks out the other end, or it no longer absorbs.

When it is full, hold a tissue or napkin over the far end and blow into the "drip" end, to blow out any extra juice. Juice that drips out into your battery can ruin it.

Pop the rubber mouthpiece back on it.

You should probably wait 5 – 10 minutes before using the freshly filled carto to be sure the juice covers the part that gets hot and creates the vapor.

If you get less vapor or a burning smell, you may be out of juice, drip more in until it is filled and start again.

These are hard to clean out to try a different flavor. Best to just wait until it is pretty much empty, put the new flavor in, and you may taste a mix for a while.

http://www.giantvapor.com/how-to-refill-a-cartomizer/

Comments

There are no comments to display.

Blog entry information

Author
Unhooked
Views
610
Last update

More entries in ECF Blogs

More entries from Unhooked