9 volt rechargeable battery for 510 mod?

3.7v standard 510 batty = 180 mAh (OK for short time)
3.7v mega batty 510 = 280 mAh (a bit better)
3.7v 10440 batty = 320 mAh (lasts a bit longer than 280 mAh)
But all of the above work at 3.7 volts.
Well what about a 9 volt rechargeable battery, why can’t this work with a HV atty?
Hitech 9V 2 Bank Smart Charger with 2 9V Lithium Ion Batteries: BatteryMart.com
Ok so maybe 600mAh is not a lot of stored charge, but it should work, no?
I used 2 x 10440 3.7 protected rechargeable battys fully charged @ 4.1v each and stacked them together to get 8.2v.
Attached some wires to then and my 510 2.2 ohm atty and let me tell you it was a blast for about 1hr.
That is till one of my 10440 protected battys drained to 0% and now this one is completely dead.
This was a test run for me so I will not cry over one dead battery, over all it was a success to vape between 8.2v down to about 6.5v until one battery died.
Not sure if stacking 10440 protected batteries caused one to die.
Anyway the big question still is, can this be done using a 9 volt rechargeable battery?
I am sure a 9v. would fit nicely in a small mod box.
Any thoughts on this idea are welcome.
Best Regards,

Comments

There are no comments to display.

Blog entry information

Author
Vadim
Views
425
Last update

More entries in ECF Blogs