E-Cigarette Forum - vjdossey - Blogs
View RSS Feed

vjdossey

  1. Newbie Question...

    by , 11-14-2014 at 05:10 PM
    Quote Originally Posted by sketchness View Post
    With mechs it doesn't matter what device you have or what atty (for this discussion), what matters is the battery. This determines what you can build within the confines of your amp limit. The links provided above go over this in detail.

    So i am sure I won't answer every question about wire but real simple stuff: Higher gauge equals higher resistance, but it heats faster which is important when you are building coils on a device that doesn't push watts like a mech. So building coils
    ...
    Categories
    Uncategorized
  2. Help with wire, wicks, etc

    by , 12-04-2013 at 05:31 PM
    Quote Originally Posted by vjdossey View Post
    Thank you so much buklao for this thread-great questions. Thrasher-super big thanks for explanations!!!
    Quote Originally Posted by Thrasher View Post
    Kanthal Wire - the wire type

    32 Gauge - the size of the wire usually we use 28 to 32 g for our resistance needs.

    0.25oz - the weight of the spool (or the weight of what your ordering)

    Series A-1 - the blend of kanthal, it comes in several versions A,A1,D

    AWG - Averange Wire Guage. the standard we use to size the wire.
    ...
    Categories
    help
  3. trying to make my own coils -need guidance-Please :-)

    by , 12-04-2013 at 05:37 AM
    Quote Originally Posted by vjdossey View Post
    Good to know, ill make note of your suggestion :-) any ideas why the leggs are burning the gromet? It happened at 3.4 volts... Coil was 2.1
    Quote Originally Posted by beckdg View Post
    that's it then. pull them just taut enough to know they're wiggling and bending at the base just under the grommet and wiggle them to "snip" them off.

    5 minutes into this video...



    i'll suggest the igo-w over the igo-l for your first rebuildable because the
    ...
    Categories
    Uncategorized
  4. Possible Stinky Grommet Replacement

    by , 11-26-2013 at 03:27 AM
    Quote Originally Posted by Trayce View Post
    Received the tubing (3 32" I D Silicone Tubing Temperature Rated to 500F | eBay) and so far it works exactly as expected! If a burny rubber grommet flavor is your problem, this should fix it. I took a few pics to share below. INSERT 16hrs LATER: There is an issue with Kanger heads but not Aro heads... see my post #5 below for details. THIS ISSUE RESOLVED ... SEE POST #12

    A couple things... the silicone tubing is softer than the stock rubber grommet so takes a little
    ...
    Categories
    Uncategorized
  5. Possible Stinky Grommet Replacement

    by , 11-26-2013 at 03:25 AM
    Quote Originally Posted by Trayce View Post
    Received the tubing (3 32" I D Silicone Tubing Temperature Rated to 500F | eBay) and so far it works exactly as expected! If a burny rubber grommet flavor is your problem, this should fix it. I took a few pics to share below. INSERT 16hrs LATER: There is an issue with Kanger heads but not Aro heads... see my post #5 below for details. THIS ISSUE RESOLVED ... SEE POST #12

    A couple things... the silicone tubing is softer than the stock rubber grommet so takes a little
    ...
    Categories
    Uncategorized
Page 1 of 6 12345 ... LastLast