Good to know, ill make note of your suggestion any ideas why the leggs are burning the gromet? It happened at 3.4 volts... Coil was 2.1
beckdg;11456909 said:
that's it then. pull them just taut enough to know they're wiggling and bending at the base just under the grommet and wiggle them to "snip" them off.
5 minutes into this video...
i'll suggest the igo-w over the igo-l for your first rebuildable because the coil legs just slip into the holes. you don't have to attempt to wrap them around a screw head and hold them while you tighten down the screw. you can take one coil off and just use one if the vapor is too much or the resistance is too low. makes it basically a much easier to rebuild igo-l with upgrade options for later.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.