Atomizers for Buzz Pro
Results 1 to 4 of 4

Thread: Atomizers for Buzz Pro

  1. #1
    Full Member
    Join Date
    Aug 2012
    Location
    greensboro nc
    Posts
    15
    Blog Entries
    1

    Default Atomizers for Buzz Pro

    i have been an lr carto guy since i have been vaping. analog free for 2 years. would like suggestions for atomizer and ohm selection for my buzz pro. looking for a better vape as always. tanks for work and i like dripping at home. pleas help.

  2. #2
    ECF Moderator Team ECF (folding@home)
    Verified Member
    ECF Veteran
    Supporting Member
    Caridwen's Avatar
    Join Date
    Jan 2011
    Posts
    7,824

    Default

    Hi pbmax!

    I'll move your post to the buzz pro subforum. You might get more responses there.

  3. #3
    Super Member Team ECF (folding@home)
    Verified Member
    ECF Veteran
    evilfrog's Avatar
    Join Date
    Jan 2011
    Location
    portland OR
    Posts
    955

    Default

    My personal current favorite is a 3.5ohm Ikenvape 901. I like the i06 quite a bit as well, and the IKV 801 is good too, though a bit airy.
    From my reading on this forum: many (but not all) drippers seem to prefer the hh 357 and Cisco-spec attys from Avid and then the IKV gear as a slightly lesser, but more affordable, option. The AVA also gets some great reviews, but I can't see parting with over $40 for a disposable atty.

    Most Buzz users get attys in the 2.5 ohm range. I'm not sure why, but I seem to get better performance from slightly higher ohm attys. YMMV - it's best to get a variety, so you can figure out what works best for you. LR attys will work fine, but battery life will suffer a little.

    Also - it would be wise to pick up a couple sealed connecters so your top cap stays dry. I did without this for a couple months with no problem, but if the oring under the screw gets out of wack liquid can get into the electronics if your atty leaks. I now put sealed connecters under all my attys as a percaution.

    Genesis attys also work fine on a Buzz. Two of mine have gennys on them at all times! A well set-up genesis is as good as (and often better then) dripping for me.
    Hardware: A bunch of mechs and regulated mods (DNA20, OKR, etc) and lots of Genesis attys plus i06s and emp901s NO CLONES!


  4. #4
    PIF Moderator Team ECF (folding@home)
    Verified Member
    ECF Veteran
    Supporting Member
    markfm's Avatar
    Join Date
    Jul 2010
    Location
    Beautiful Baldwinsville (CNY)
    Posts
    9,158

    Default

    Total run time with 3 ohms is better than with 2.5, by a bit, for a given total watts, based on my experience, it's just that 2.5 ohms let you get a couple more watts at max voltage if you want a bit more oomph from time to time.

    Sealed connectors are a biggie. With my 801 fusion tank/carto setup I use a native 801 top cap, but that's because I've had stellar, consistent, performance with that combination, I believe only one dump condition in a full year. With atties you can absolutely expect to give the connector a soaking for at least a little while -- it takes time to get the hang of them. A sealed adapter is a very smart addition.
    Pay It Forward Learn to laugh at yourself -- why let everyone else have all the fun :)
    http://www.e-cigarette-forum.com/forum/diy-e-liquid/

Bookmarks