New technology it is possible to make at home renewed boilers. The electric cigarette NGP's two boilers can be restored to order. One is made of a fiberglass bow with which the resistance wire to the glass fiber filaments around the reels and the other tissues of the metal guide tube with a finely woven metal fabric tube shape to format, and place the coil around it. Currently, the technology of the metal fabric tube boilers, Genesis renewed use.
The glass fiber is a regenerated brain built boiler is supplied with or affecting the brain may be mechanical switches. The boiler is renewed on the basis of a heat-resistant plastic boiler is located, two screws which hold the base ellenálláshuzalt a bow with glass fiber. The ribbon drawing some very simple steps (at the bottom of the preparation in the form of videos viewed ):
Bow
Bow first record step
Fixing the second bow step
Fixing third Bow step
Roll the glass in the desired amount (usually three-thread) a 18mm diameter cylindrical object (such as the NGP into the battery with a purpose) so as to be overlapped at one point in the fiber.
Pulled from the battery so that the fibers do not shift around.
Together in one end of the flat ribbon shape is obtained.
We are taking a guide wire, which is sufficiently robust to the resistance wire, not to lean forward, and we will add a horizontal ribbon.
An approximately 8 cm long piece of resistance wire, make the roll, it is important to us that the two end / face-down, straight ahead. Seek the appropriate setting is usually used to be four, but feel free to experiment with more or less well. The threads should be tight, even. The distance between the threads can greatly affect the taste, it should be noted. The finished, equipped bow slightly changed location of the threads later.
The glass fibers may extend the end cut off.
The renewed boiler loosen the two screws and then put upon the bow of the segéddróttal with resistance wire and the two ends of the two fixed screws. Let us make sure that the glass fibers do not tamper with the screw! It is also important that the resistance wire ends tight fix.
At this point the distance is not adequate, or even more threads megigazgathatjuk.
Justifying the bow so that it is positioned over the two screws and gently pull out the auxiliary wire.
Átbujtatunk a small piece of fiberglass bows and loops of the loop by a simple double knot, tie up top. The first node after a drop of liquid drops knots raising a lot stronger than the second, there will be stronger, it will not dissolve.
Megigazítás after projecting ends of the fiber bundle used to cut, if we leave half an inch, the node will definitely not dissolve. Cut off the protruding ends of the resistance wire as well.
Liquid completely wetted the knot, and put upon the cartridge or drip kiupakot and try it! You should try drippelve cartridge case before the final bow!
The bow can be used to regenerated boiler vatelines cartridge , fabric or metal tube arresters mounted boiler tank and use drip cap , in this liquid to drip like cup drippelt exactly the center of the bow knot will fall.
99Likes
LinkBack URL
About LinkBacks
NEW/ODD APVs models you found,post them here!
Reply With Quote
Originally Posted by ChellyNelly
Bookmarks