Cartridge Modification

[Archer74]

Thanks for retitling, Sun!

510 cart mod


Warning!:

1) Be VERY careful where you position the staple. too close and or too narrow can shred your bridge if you twist the cart!
2) Not recommended for autobatts or PT with a hole.
3) Not recommended for vented carts.


Notes:
1) you can extend the PTB all the way down to the bottom
2) refill at an angle dropping liquid on one side if possible
3) Needles and syringe better for refilling
4) You may need more layers depending on viscosity of the liquid.
5) PTB must be able to bend for the atty.

[tyfighter]

I'm trying this now.

It passed both the "Didn't flood the atty" and "Holy Balls, that's a lotta juice going in there" tests. Lets see how it holds up after more than the ten minutes I've been testing it

[tyfighter]

ok, I've been vaping on the same cartridge pretty solidly for a hour and a bit and I think I'm in love with this mod, every drag tastes new.

My Method:
1. Poke four holes in the flat sides of the (510) cart, I used a swiss army knife for this
2. Push the staples through the holes on either side, take care that they are not too close together or too close to the top.
3. Fold a small piece of PTB over twice, so you get a rectangle with four layers of PTB
4. Slide one end between the staple and the cart with the seam pressed against the plastic.
5. Slide the other end into the other side
6. Fill and enjoy!

You may have to repeat steps 3-5 until you get good coverage of the cartridge hole.