Must Try! ADM auto drip mod

[Stehle]

Just a thought.... Plastic Springs hopefully someone else finds them useful.

[youtubecommercial]

Wow I tried this ... Lol you should have seen the spring inside ,,, now I got to get me some wire cutters,,, nothing else will work .... hahaha .... I found out the hard way

[youtubecommercial]

Just a thought.... Plastic Springs hopefully someone else finds them useful.

And now I see this ..... Thanks

[thana]

I am a little confused on 1 thing, there is no poly at the end of mouth piece, wont the liquid drop out when you draw on it?

[kristin]

I am a little confused on 1 thing, there is no poly at the end of mouth piece, wont the liquid drop out when you draw on it?

There is no hole there. When you get liquid in your mouth, it's because too much is getting into the atomizer chamber and running into the vapor vents along side the cart and back into the mouthpiece.

Look at the diagram. (This is using a straw instead of a spring.) Those long channels along the side are how the vapor gets to your mouth. The liquid reservoir isn't open to the mouthpiece directly.

[Closet Toker]

I've been using the blue fish filter material with this spring mod., along with the straw mod.

Combining both of these mods, works great.

I finally have a cartridge that can supply the demand of my Prodigy.

My atomizer stays much cooler, compared to dripping. This should extend the life of my atomizer also.... sweet!

[thana]

So wow thank you. You were very helpful. I just did the mod, works great. Ushually I onlly get three drops of vaping (I constanlt have to add three dropd and three drops only.) How many drops will I get out of this? If I alow gravity to refill the the poly will it use up the whole resivour?

[wiscguy]

So Im confused. I thought I didn it correctly, but I keep getting liquid in my mouth....a lot of it. Is it possible that I didnt use enough poly material?

[kristin]

So Im confused. I thought I didn it correctly, but I keep getting liquid in my mouth....a lot of it. Is it possible that I didnt use enough poly material?

Yes. Try adding more poly or using a different material. You want it to act like a plug on the end of the cart. If it's dense just enough, it'll just get saturated with liquid, but not allow too much to go through.

[PlanetScribbles]

Is there any reason why you couldn't cut the hollow shaft of a q-tip into several equal length bits and stick them in the cart? It seems to me that that would well up the excess liquid even better than a spring?