Dan, I'll be placing an order for some more lorann flavors. Since I was looking all your recipes over figuring what flavors to get I noticed a little error. That being Brandy mentioned for both flavor columns. I only bring it up as it may save you some more questions, probably not though.
Napoleon Dollop!100%Brandy (Lorann)67.0% Brandy (Lorann)33.0%
I ran from 7% up to 30% with the MJ and never came close to what I was looking for. Kinda silly working with that flavor any ways, more as a novelty to surprise a few friends. You've got some nice bells and whistles on 13v, I was working with 11v, don't know how I missed 12v. Well I'm off to ebay.
Thx for the help
Last edited by Nikhil; 05-28-2010 at 12:23 PM.
Reason: removed a couple hundred lines of blank space
From what I gathered from the litecigusa juice selection, the RY menu has to do with the ratio of caramel, vanilla and tobacco...they hint at what is what BUT I really like RY4 and the flavor is not consistent with different samples I have tried. That said I did try litecigs RY2 and was blown away with the richness....it was really good.....
hope this helps
Last edited by mphsjeep; 05-28-2010 at 12:06 PM.
Provari V2! - eVic - Sigelei ZMax - AnyVape CVI V1 - modded PureSmoker Prodigy V2.1 - modded old school Protege
Dan - I'm back with the flavors
Attached is the calculations from ejuice cal.13v
I'm using 100mg/ml PG nic
all lorann flavoring
I wonder since I like everything strong if I should mix my flavor @ 15%? I believe Dan suggests 10%?
I know how sensitive to error RY4 can be so I'm mixing 30ml to help reduce that error factor. This is also why I'd like to mix exactly what Dan suggests. For right now I'm going to wait for suggestions and mix the tobacco (50% commercial 50% Tobacco Absolute). I pretty much know how I like that. Only now I've got a better system for accuracy and repeatability.
Thanks to all
I love RY4. A lot. I think it's awesome.
I want to try RY1, 2, and 3.
I think I'll like them all. Something about the combo of caramel and tobacco is just sooo good. No matter what the ratio I think it'll be tasty.
I have all 4. RY1, RY2 and RY3 are all similar and to my taste have NO sweetness at all... unlike RY4. They are real strong tobacco flavorings and the order of strength goes up. RY3 being the strongest. I like them all and RY3 is my favorite... but it will knock you down at 6 volts. It's really strong!
I'd love to try 1,2 & 3 myself. I just purchased some RY4 and was again disappointed. Not a bad vape just not RY4.
Originally Posted by jiff
I've had just straight Runyan and the taste was great. RY1, 2 & 3 I've never even seen, but then maybe I wasn't paying attention to them. I do love strong tobacco flavor. Yesterday I mixed 3 recipes, tobacco at 24mg/ml & 12mg/ml and Jolly Rancher at 12mg/ml. I believe I'll try RY4 today but only mix 15ml at 10% flavor. If it's to weak I'm sure Dan will be around to advise me how to fix it.
Originally Posted by JRWReich
thanks for the input
Well I mixed the mix. But I didn't have all the lorann's flavors and used PA for caramel and marshmallow. PA flavors overpowered the whole mix way to sweet. So for now I put some more commercial concentrate and a little of PA's tobacco blend to make the stuff vapeable. Since madvapes is a great vendor I ordered some RY4 & 555 just to refresh my taste buds. I have checked into many sites and have found RY1 thru 4. If I'm not that happy with what I get from madvapes then I'll order the other RY's. In the meanwhile I'm still trying the DIY, 1st I'll vape what I got.
again thanks all
Tags for this Thread