Video Review of the Revolver Elite e-cig with PCC

**Mainer** · 10-21-2009, 08:15 PM

Originally Posted by Scottbee

I placed my order 4 days ago and it is still listed as "Processing". I'll give them two more days.... if it hasn't shipped by then, I'm canceling it. It was more of a curiosity than anything else......

I just got mine, and the orders status never changed from "processing", so I'm guessing yours has probably been shipped.

**kevbow** · 10-21-2009, 08:38 PM

I've had my revolver for a while now. I'm happy with the overall performance but the only problem I had was that it was not draining the carts. Vapor production would die off and I would have to take the cart out and mess with it to get it to work right again. But.....I have come up with a fix for that.....as soon as the video is done I will post it....thing vapes like a champ with the fix.

**Scottbee** · 10-21-2009, 08:40 PM

Originally Posted by Mainer

I just got mine, and the orders status never changed from "processing", so I'm guessing yours has probably been shipped.

That may very well be. They haven't responded to my EAMIL from last night yet. Not getting the "warm fuzzy" feeling..... but I'm not going to over-react.

**Scottbee** · 10-22-2009, 01:06 AM

Update... I got a "your item has shipped" EMAIL from them today.. and then when I got home it was here! Strange.

I have a cold and I'm in a generally bad mood... so I won't even try to do a review right now!

**Scottbee** · 10-22-2009, 01:27 AM

Originally Posted by Snarkyone

Just an aside to the people that are not too pleased with the m401 carts being "hard" to put back, use the plug that came with the cart to keep the liquid in to push the little reservoir cup back into the filter cart. It pushes it down the perfect amount of space and you don't have to jack with trying to angle a paperclip to do it. Only drawback is that you still need the paperclip to get the cart out.

Why not just use the atty to push the cart back into the right depth? Afraid it will hurt the bridge?

**Nikko Daniels** · 10-22-2009, 02:06 AM

Originally Posted by Scottbee

Why not just use the atty to push the cart back into the right depth? Afraid it will hurt the bridge?

That method is likely to push the filler down into the cart. If this happens you'll get a couple good draws and then it'll taper off into next to nothing, just like a good drip or dip.

You want the atomizer bridge to just contact the filler and slightly compress it, maintaining contact with the fibers so it can wick the fluid away from the cart and into the inner coil of the atomizer.

Pushing it all the way down with either the rubber stopper or a fat paperclip has, for me, enabled a pretty much complete drain of the cart, consistently, with the Revolver and 401.

**Lurkiee** · 10-22-2009, 10:04 PM

I get good vapor, but a horrid burnt taste. Could it be the attys still have primer in them, after 2 days?(being new I didn't realize you needed to clear them out beforehand) I tried dripping and same blag taste. Since the Revolver site is out of attys does any one know if anyone else sells attys that fit the Elite?

Thanks