Atty's resistance or "Ohms"

[nephillim]

Has anyone tried determining if the resistance on an atomizer changes when its nearing its end of life or just too dirty? This might be able to help us understand more about them.
I would test this theory, but I just started vaping and haven't *knocks on wood* lost any atty's yet.

Just a thought..




"i'm getting a little verklempt, talk amongst yourselves"

[Majestic]

From my experience with the 901, the atomizers don't die gradually. They vape good one minute and are cold the next. I usually get around 3 ohms with a good atty and 1000++ ohms with a dead one. Dissection of the decedent usually shows a broken wire as the cause of death. The fact that a dead atty is still showing a high ohm reading is likely due to the wet gunk that adheres to the coil wires.

[breakfastchef]

Zero ohms, atty is dead; 3.5ish ohms, atty is functioning properly; high ohm reading, the atty is FTD (fixin' to die).

[oldienea]

Whenever I have a doubt, I check them. Till now, I did never observe any other reading, than either the original 3.5 to 3.7 ohms, or none.

Not all attys have the same default resistance. Some ohm meters have a specific false reading of about up to 0.5 ohms. Check it first, by holding the two pins together.

[smokinbob]

I just checked mine, I get 3.5 ohms on my 901 atomizer and I've been using it for almost a month now.

[smokinbob]

also, as the post above states, I get 0.4 ohms as a false reading.

[Kelemvor]

one of my 801 janty reads 43 Ohms now, a few days ago it stopped working with 55 Ohm.

i would check whats up with that piece, but it will be changed... at least i hope.

[breakfastchef]

one of my 801 janty reads 43 Ohms now, a few days ago it stopped working with 55 Ohm.

I throw out my 801 atomizers when they read above 20 ohms. At that point, it is too hard to get them to produce any decent amount of vapor.

[Vanguard]

I get a resistance of 3.2-3.3 ohms from a new atty (RN4081).

[markarich159]

Zero ohms, atty is dead; 3.5ish ohms, atty is functioning properly; high ohm reading, the atty is FTD (fixin' to die).

Mathematically speaking a dead atty would have infinite resistance, according to Ohms Law. just an observation.