HOW do I test my atty's?

[Mingolvr]

Got the ohm meter out, new battery and all.

Touch the outer threads of the atty and the bridge and get a reading of 0 ohms, I touch the outer threads and the center bit on the batt end of the atty and get the same thing..yet this thing vapes like a fog machine..

What am I doing wrong? (oh, and I DO know how to use the ohm meter, and yes, I zero'd it out....

Help?

[Majestic]

Make sure you are using the X1 setting of the Ohms meter.

I check attys by putting one terminal of the Ohms meter in the side vent hole and the other terminal on the center connector of the battery end.

[firhill]

Test the battery end of the atty.

Red probe on centre connector and black on the threads.

What model atomizer? New 901's read about 3.3ohms.

[Mingolvr]

510 atty's and that's how I'm doing it...

I don't get it...I've checked 10 more atty's and have the same result...bad meter maybe?

Edited to add: went and tested a few other things and they check out fine...just not the attys....