Poor connection or dead atom?

[Sun Vaporer]

It sorta worked. I can get the atomizer to heat, but the batt is now a hard draw...and fades almost instantly. I wonder if I pulled a bit too hard.....

Puff--sounds like you are almost there but not a full connection--pull it out somemore--it will not break---Sun

[puff-puff-pass]

Puff--sounds like you are almost there but not a full connection--pull it out somemore--it will not break---Sun

I pulled and pulled until it was visibly higher than before. It gets the atom hot but is just too hard to draw...
Plus I think i made it worse...now the brass connector is turning in the batt housing.

[trollmonger]

I pulled and pulled until it was visibly higher than before. It gets the atom hot but is just too hard to draw...
Plus I think i made it worse...now the brass connector is turning in the batt housing.

Hey, i had a batt that wouldn't heat the atomizer and what i did was take a needle nose pliers and take the band off the battery end of the atomizer then i ground off with my wheel grinder in my garage abour .03 off the now brass colored end of the atty.... making the battery screw further down and contacting the atty pole.... works like a champ now.

[Sun Vaporer]

I pulled and pulled until it was visibly higher than before. It gets the atom hot but is just too hard to draw...
Plus I think i made it worse...now the brass connector is turning in the batt housing.

Puff--how tight are you twisting it down? The battery thread is a real pain to get out of the housing as we take them out all the time for MODS--and you really have to work it to loosen that press fit in the battery to get it out. Try waking that battery thread side down on the floor to get it back in there tight and see if that makes a difference--Sun