Metal or Glass tip for dripping

[DaMulta]

Well I just melted another cart in my 510 from dripping. Who is with me on the idea of reusable carts for dripping that are made of glass or metal for those who drip?

[SLDS181]

Personally, I stopped using a cart.

[breakfastchef]

I drip and have no cartridge in my atomizer. Are you topping off or dripping? Also, heat is the only thing that could possibly melt a cartridge in an atomizer. Dripping does not cause more heat. How did you come to the conclusion that dripping caused your cartridge to melt? Perhaps I do not understand the anatomy of a 510.

[DaMulta]

Well I think the cart gets weaker with time exposed to the atomizer with out switching it out for a new one. This is not like using fresh carts where the user would switch them out after a few days.

[Porphy]

I have a great idea for a new cart for dripping, my only snag is that I'm horrible at 3d renderings and I haven't the first clue how to fabricate it via plastics or metals.

Basically, the idea would be have a small funnel that leads right to the top of the atty bridge. My only issue is creating it. I think it would be better than having no cart as it would allow for "precision dripping" right onto the bridge... I know I've missed the mark a few times when in a rush or drunk.

[Walrus]

I just use the dummy mouthpiece that comes with the atty for dripping. But in response to the OP, I'd think a metal tip would conduct the heat of the atty to your lips, so you might as well just 'tail pipe' it... and that can get uncomfortable on a 510. An 801, not so much.

[DaMulta]

Well today I have been using one of those rubber ends to a pen for the finger grip on my 510. So far it has worked really well.