Atomizer and the primer lube . in The E-Cigarette; As all know, "a new atomizer is a good atomizer" (most times...).
I think that this very thick vapor ,produced ...
-
Full Member
ECF Veteran
Atomizer and the primer lube .
As all know, "a new atomizer is a good atomizer" (most times...).
I think that this very thick vapor ,produced by a new atomizer is coming from the primer lube that comes from the factory. ones it is gone, the atomizer goes downhill. and even if washed/boiled/steamed etc. it will never get back to the days when it was new and produced very thick vapor because the orig lube is gone.
I also think that maybe some people smoke this lube quickly , not adding juice because they feel heavy thick vapor.
My point is , that if you want to prolong the time that this primer is in the atomizer, you need to refill/ top /drip the atomizer as soon that you taste the atomizer lube (neutral taste) , so you don't cook this primer.
eventually this primer will be gone anyway , but better not to finish it in few days/sometimes hours .
-
Hmmm, good point! I'll start doing that with new atomizers.
-
its just e liquid.. a simple two or three drop reprime has it as good as new..
when a cart dries out so does the wire wool around the atomizer pot thats primed.. a couple of drops before a new cart is fitted puts it back..
when carts are wet topped up it dosnt need doing only when they are let dry out... just popping a new cart in dosnt wet the wire wool enough if its been sucked too dry..
trog
the reason its done is without the wire wool being wet the device simply dosnt work..
wire wool feeds the atomizer coil.. cart wool keeps the wire wool wet.. with a mini the wire wool holds more than half what the cart wool holds.. quite a lot..
Last edited by trog100; 12-28-2008 at 03:07 AM.
-
Full Member
ECF Veteran

Originally Posted by
trog100
its just e liquid.. a simple two or three drop reprime has it as good as new..
when a cart dries out so does the wire wool around the atomizer pot thats primed.. a couple of drops before a new cart is fitted puts it back..
when carts are wet topped up it dosnt need doing only when they are let dry out... just popping a new cart in dosnt wet the wire wool enough if its been sucked too dry..
trog
the reason its done is without the wire wool being wet the device simply dosnt work..
wire wool feeds the atomizer coil.. cart wool keeps the wire wool wet.. with a mini the wire wool holds more than half what the cart wool holds.. quite a lot..
Still, with a new atomizer, for few days, when the flavor of the juice you put in, let say 2 drops using the dripping method runs out , you get this natural flavor. isn't it the primer? do you say that the primer lube is regular pg?
I never used carts, so I know that 2 drops is 10 puffs or so...
-
i dont know what kind of liquid they put in only that its has to be there.. its the first stage in the process so to speak.. it gets diluted down quite quickly even thow some of the taste can linger..
if a 901 atomizer is ever fully dried out by blowing boiling or whatever it takes four or five drops to reprime the wire wool that surounds the little pot the heater coil sits in..
the stuff in the bottom section of wire wool can thicken up as well making the atomizer hard to draw thru.. air has to pass thru the wire wool on its way to the heater coil.. it pulls liquid along with it as it does..
all the cart does is to top up the wire wool.. the wetness of the wire wool is the important bit.. which is why it all works quite well with direct dripping..
trog
ps.. normal usage never fully empties the wire wool.. two drops keeps it all going but the wool really holds a lot more than that..
Last edited by trog100; 12-28-2008 at 03:12 PM.
-
Senior Member
ECF Veteran
I think Trog has it right here. I have several atomizers that had weakened, even when dripping some juice down the side. After reading his analysis I dripped a few drops right on the mesh. 2 out of 3 atomizers are now producing nice thick vapor. The third must be just gunked up so I'll try boiling it again...
-
the heart of it all is a small wire coil.. this wire coil is wrapped around a piece of wick material.. it sits in a little pot.. this wick material soaks up e liquid.. the coil is heated to near red hot temperatures.. the liquid in the wick the coil is wrapped around then gets vapourized..
so what goes wrong...
the small piece of wick goes solid and dosnt hold liquid any more.. this happens after xxxx number of puffs.. there is no answer to this except a new atomizer..
the heater coil dosnt get hot enough to do its business.. some do some dont.. none do when the battery wears out..
the wick thing dosnt get enough liquid fed to it.. again some work some dont.. direct dripping works but is a nuisance..
it all pretty simple but does rely on everything working for the cig to work.. if one part of the system isnt working nether will the e cig..
trog
-
e - liquid? sorry I'm new, on day three, and already getting weak smoke even after changing the filter...tx
-
e liquid is the wet part of a cart.. it can be bought separately.. in little bottles..
there is no "filiter" simply a plastic tub full of wet woolly stuff..
trog
-
thanks Trog.
I just called smokingeverywhere.com and they said they don't have any liquid for purchase and their atomizers don't need to ever be cleaned.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Bookmarks