new atomizer for DSE801 SUPER hard to draw :(

[siggywiggy]

I just ordered 4 new atomizers and was SOOOO excited about using thtm. Well I just tried 2 of them and they BOTH are so hard to draw. The smoke is fine, but the difficult draw really REALLY detracts from the pleasure.

Is it the supplier? Just a bad batch? Is there anything I can do?

[ZambucaLu]

I always had a hard time drawing on my 2 holers....I found the 4 holers a much easier draw. Can you tell which you have?

Lu

[Belowme]

is the 801 a penstyle?

[siggywiggy]

oops, I meant 901 (don't have my contacts in, hehe). Just edited the thread title.

[Papa Lazarou]

Never found a hard draw on any 901's (except when they get old and clogged after a lot of use).

What type have you got, the pointy wire bridge type or the more rounded ones?

[Kate]

I had two 901 atomisers, one was black and worked a treat and the other is white and is hard to draw and gives hardly any vapour.

I lost my black one

[trog100]

try blowing hard from the battery end.. blow the liquid out onto a tissue.. then reprime the atomizer with four drops of fresh liquid..

also make sure the little air hole in the side isnt partially blocked..

the RN flatter bridge type do have a noticeably smaller air hole in them than the pointy bridge DSE ones..

trog

[Belowme]

lol its all good, I thought I was missing out on something, lol

oops, I meant 901 (don't have my contacts in, hehe). Just edited the thread title.

[jimgman]

i'd say just give them a little time to break in maybe, although not too sure what you mean by "hard to draw". hard to get the led to light? not getting enough vapor? your sucking but no air is coming through(the impression your giving, but least likely i would think, since brand new not likely clogged).

[siggywiggy]

I mean it feels like my finger is covering the hole when I draw. The vapor is great....definetely works fine. Just not fun to suck on! lol Guess I'll just deal until the new Janty comes out