Manufacturers/Suppliers: What's in your cartridges? - Page 12 - e-cigarette-forum.com • The place for electronic cigarette reviews, news and chat

katink · 08-13-2008, 05:46 PM

Thanks

(and this is to make the board accept this message)

ozrick · 03-16-2009, 06:06 PM

this thread seems to have died, any further word? Last post stated acrylic was used as the batting and it doesn't burn at the temperatures the atomizers normally get to (under regular use).

Just makes me wonder about the manual switch on the Janty-C and if holding it too long could actually cause the fiber to burn.

Sorry for churning up an old topic, I'm new to vaping and was curious.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-13-2008, 05:46 PM	#111
katink ECF Veteran Join Date: Apr 2008 Location: the Netherlands Posts: 1,235 Tweet this post!	Thanks (and this is to make the board accept this message)

03-16-2009, 06:06 PM	#112
ozrick Supporting Member Join Date: Mar 2009 Location: Chicago, IL Posts: 289	this thread seems to have died, any further word? Last post stated acrylic was used as the batting and it doesn't burn at the temperatures the atomizers normally get to (under regular use). Just makes me wonder about the manual switch on the Janty-C and if holding it too long could actually cause the fiber to burn. Sorry for churning up an old topic, I'm new to vaping and was curious.